My Partners Design

This is a step by step I’ve created for my partners design so I find it easier on the day of the assessment. 

Need-

Pintail comb

Paddle brush

Divider clips

Curby grips and geisha pins

Padding

Crimpers

Pearl hair grips 

1. Create a section at the top middle of the head, making sure the width is quite wide. Leave a small section at the front sides and back to crimp.

2. With the middle section, make a French plait and clip to the head as structure for the padding. 

3. place the padding onto the French braid and curby grip into place. 

4. With the remaining top section, crimp and place over the padding, creating a large part of padding. 

5. section off a small amount of hair at the front on both sides of the head for plaiting later on. 

6. Then with the remaining hair, split in the middle creating to equal sections. Clip one and keep the other loose. 

7.   Then section this half into three horizontal sections. French plait the middle section and curby grip in place to support the padding. 

8.   place the padding on the plait.

9.   crimp the remaining two sections and place over the padding, secure with geisha and bobby pins. 

10.   repeat this to the other side.

11.   With the remaining bits of hair at the front, plait and bring round the each section of padding and secure underneath.